HBM DWS2103 Kurzanleitung Seite 31

DWS2103
Error code Description
50xx Load cell with address xx not supplying
measured value
51xx Load cell with address xx has incorrect F
number
52xx Load cell with address xx has incorrect TRC
status
5801 Measurement invalid
5802 No standstill
Error code Description
8x01 Input buffer overflow
8x02 Overrun
Possible causes:
Incorrect baud rate, parity settings
8x03 Parity error
Possible causes:
Incorrect baud rate, parity settings
8x04 Framing error
Possible causes:
Incorrect baud rate, parity settings
8x05 Framing error
Possible causes:
Incorrect baud rate, parity settings
x represents the interface e.g. 8101 error at COM1, 8201 error at COM2, etc.
Error code Description
9100 SD card error
9123 SD card full. It is not possible to store further
Alibi print data.
9200 EEPROM error
95xx Error ESR, BIT2 (ADC OVFL), ADRxx
96xx Error ESR, BIT3 (EEPROM), ADRxx
97xx Error ESR, BIT4 (Excitation voltage), ADRxx
98xx Error ESR, BIT5 (parameter input), ADRxx
The battery is only important for the real-time clock function. The device also
works without a battery. In this case, the date and time have to be reset after
a power failure (see system CD).
A2936-1.0 en/de
Measurement
Remedy
Carry out busscan or test load cell (Test
menu), emergency operation possible if
only one load cell fails per segment
Reload load cell with parameters (Menu
Adjust/Repair) or replace load cell
Reload load cell with parameters (Menu
Adjust/Repair) or replace load cell
Printout measured value at 0
Printout 2x same measured value
Standstill conditions not applicable
during measured value printout
COM1−4 interfaces
Remedy
Hardware
Remedy
Test load cell (Test menu)
Carry out a BUSSCAN
Carry out a BUSSCAN
Replace SD card
Replace load cell
31
HBM