Preparing The Surface To Be Sprayed; Bringing Into Use; Selecting The Nozzle; Switching On / Off - Parkside PFS 100 B2 Bedienungs- Und Sicherheitshinweise

Advice on use / Bringing into use
Use a suitable thinner to achieve the required
thinning of the medium.
½
Never exceed the maximum viscosity for the
device. The sprayed medium must not be too
thick for the spraying process, otherwise it
could clog up the device.
½
Ensure that the sprayed medium and the thinner
are compatible with one another. If the wrong
thinner is used, it can lead to lumps forming
which may clog up the device. Never mix nitro-
thinners with synthetic resin paint.
½
Consult the sprayed medium manufacturer's
documentation for information about suitable
thinners (water, solvents).
1. Thoroughly mix the unthinned sprayed medium and
bring it to average room temperature (20 - 22 °C).
Do not increase the temperature to change the
viscosity.
2. Add a suitable thinner.
3. Test the viscosity as described above (see Fig. C).
NOTE: Never use nitro-thinners to thin synthetic
resin paint!
Example of
material
Car body paint
Acrylic paint
Synthetic resin paint
Primer
Wood impregnation
Glaze
Hammer finish paint
Emulsion paint
* This device cannot be used to spray media contain-
ing discrete particles / solids. The abrasive effect
of these media shortens pump and valve life.
©
Preparing the surface
to be sprayed
The surface to be sprayed must be clean, dry and
free of grease.
10 GB
DIN guidance
value
16-20 DIN-sec
25-30 DIN-sec
25-30 DIN-sec
25-30 DIN-sec
25-30 DIN-sec
25-30 DIN-sec
30-35 DIN-sec*
40-80 DIN-sec
Roughen smooth surfaces and remove any
abraded dust.
Always cover the surrounding area around the
surface to be sprayed. The spray cloud may
contaminate the surrounding area.
©

Bringing into use

©

Selecting the nozzle

Nozzle
Nozzle, 0.6 mm
Nozzle, 0.8 mm
Cleaning nozzle
Nozzle extension
©

Switching ON / OFF

Switching on:
To start the electrical power tool, press the
ON / OFF switch 3
Switching off:
To switch off the electrical power tool, release
the ON / OFF switch
©

Spraying process

1. You can vary the spray by adjusting the regulator
button (see Fig. D). The spray is correctly
2
set when no drops are formed and the gun
produces a fine, consistent spray pattern.
2. Do not switch the device on or off while it is
over the surface to be sprayed. Instead, start
and stop the spraying process approximately
10 cm outside the surface to be sprayed.
NOTE: The distance between the nozzle and
the workpiece depends on the material being
sprayed (approx. 20 to 35 cm spraying dis-
Use
all paints, varnishes
thick-flowing sprayed
media
a thinner, harder spray
for spot-cleaning of sur-
faces
for spraying in high or
low, more difficult to
reach corners
and keep it pressed.
.
3