Herunterladen Inhalt Inhalt Diese Seite drucken

Preparing The Surface To Be Sprayed; Bringing Into Use; Selecting The Nozzle; Switching On / Off - Parkside PFS 100 C3 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Farbspritzpistole
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Advice on use / Bringing into use
Material
Latex paint
Water-based paint
Primer
Lacquer
Oil-based paint
Glaze
Aluminium paint
Wood sealer
Wood preserver
Wood stain
* This device cannot be used to spray media contain-
ing discrete particles / solids. The abrasive effect
of these media shortens pump and valve life.
Preparing the surface
Q
to be sprayed
The surface to be sprayed must be clean, dry and
free of grease.
R oughen smooth surfaces and remove any
abraded dust.
A lways cover the surrounding area around the
surface to be sprayed. The spray cloud may
contaminate the surrounding area.

Bringing into use

Q

Selecting the nozzle

Q
Nozzle
Nozzle, 0.6 mm
(R6)
8
Nozzle, 0.8 mm
(R8)
8
Cleaning nozzle
12
10 GB/IE
Flow rate in
seconds
24 – 28
20 – 25
24 – 28
20 – 25
18 – 22
18 – 22
22 – 25
28 – 35
No diluting
required
No diluting
required
Use
all paints, varnishes
thick-flowing sprayed media
a thinner, harder spray for
spot-cleaning of surfaces
Nozzle
Nozzle extension
14

Switching ON / OFF

Q
Switching on:
T o start the electrical power tool, press the
ON / OFF switch
3
Switching off:
T o switch off the electrical power tool, release
the ON / OFF switch

Spraying process

Q
1. You can vary the spray by adjusting the regulator
button
(see Fig. D). The spray is correctly
2
set when no drops are formed and the gun
produces a fine, consistent spray pattern.
2. Do not switch the device on or off while it is
over the surface to be sprayed. Instead, start
and stop the spraying process approximately
10 cm outside the surface to be sprayed.
NOTE: The distance between the nozzle and
the workpiece depends on the material being
sprayed (approx. 20 to 35 cm spraying dis-
tance, depending on the spray cone and the
desired amount of material to be applied).
U se the device in a horizontal orientation only
(as shown in Fig. D).
C arry out a trial in each case to determine the
most effective spraying distance.
S tart with a longer distance.
3. Spray corners or small decorative details first
using short bursts of spray.
Then go on to the actual spraying process.
4. The spray process should follow the sequence
shown in Fig. E
– keep the spray gun moving parallel to the surface
– Do not incline the spray gun
– Move the spray gun at a constant speed
– Apply the sprayed medium as thinly as possible
– The layer(s) of sprayed medium need(s) to
be allowed to dry for some time before you
Use
for spraying into corners
which are difficult to reach
and keep it pressed.
.
3

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis