Agilent Technologies TPS-compact 969-8217 Bedienungshandbuch Seite 248

17 Technical Information
Window Protocol
N. Read/ Data
Write Type
402 R A
404 R A
406 R A
407 R A
500 Reserved to Agilent service
503 R/W N
504 R/W L
1. Automatic means that when the controller stops, the vent valve is
NOTE
opened with a delay defined by window n. 126; when the
controller starts, the vent valve is immediately closed.
2. On command means that the vent valve is opened or closed by
means of window n. 122.
3. These commands remove the pump motor supply for a short time.
If they are used continuously, they can cause the pump stopping.
Figure 39
248/262
Description
CRC Param. (PA)
CRC Parameter structure
Program Listing Code
Parameter Listing Code
RS 485 address
Serial type select
7 6
TOO HIGH LOAD
SHORT CIRCUIT
OVERVOLTAGE
Windows N. 206 Bit Description
5 4 3 2 1
CONTROLL. OVERTEMP.
TPS-compact User Manual / 87-901-010-01
Admitted Values
PA8XXXX (where "XXXX"
are variable)
"XXXX"
"XXXXXXXXXX"
"XXXXXXXXXX"
0 to 31 (default = 0)
0 = RS 232
1 = RS 485 (default = 0)
0
NO CONNECTION
PUMP OVERTEMP.
(C)