Insufficient Suction; The Brush Motor Or The Suction; The Squeegee Doesn't Clean Or Dry Efficiently; The Battery Charger Doesn'twork - Comet CRS 66 BT Bedienungsanleitung

 The suction motor is turned off.
 Activate it.
 The recovery tank is full.
 Empty it.
 The suction motor is not receiving electric power or is
burned.
 Check the connections and, for the latter case,
replace the motor.
9.2.6

INSUFFICIENT SUCTION

 The recovery tank cover was not correctly tightened.
 Tighten it correctly.
 The recovery tank drain hose plug is not perfectly clo-
sed.
 Close it correctly.
 The suction hose, the squeegee conduit or the
inspection compartment is clogged.
 Clean out and remove any obstructions from the con-
duits.
9.2.7 THE BRUSH MOTOR OR THE SUCTION MO-
TOR DOESN'T STOP
 The relay switch is defective.
 Stop the machine, cutting off the main power supply
and disconnecting the main battery connector, and con-
tact the technical service centre.
9.2.8 THE SQUEEGEE DOESN'T CLEAN OR DRY
EFFICIENTLY
 The squeegee blades are worn or are dragging solid dirt.
 Replace or clean them.
 The squeegee adjustment is not correct; the
advancement must be exactly perpendicular to the run-
ning direction.
 Adjust the squeegee.
 The suction hose, the squeegee conduit or the
inspection compartment is clogged.
 Clean out and remove any obstructions from the con-
duits.
9.2.9 THE BATTERY CHARGER DOESN'T WORK
 The battery charge doesn't start.
 Check that the battery charger is connected to the bat-
tery. Consult the battery charger manual.
9.2.10 THE BATTERIES DO NOT CHARGE OR DO
NOT HOLD A CHARGE
 At the end of the charging process, the battery is not
correctly charged (see the battery manufacturer's instruc-
tion-maintenance manual)
 Check the battery charger error message and check the
data indicated on the display (see the battery charger's in-
struction manual).
 The batteries are new and do not generate 100% of the
rated performances.
 The accumulator reaches the maximum performance
after 20-30 complete charge cycles.
 The electrolyte has evaporated and does not
completely cover the plates.
 Check the battery manufacturer's use and maintenance
manual.
 There are significant differences in density among the
various elements.
 Replace the damaged battery.
Always consult the battery and battery charger use and
maintenance manual. If this does not solve the problem,
contact the authorised technical service centre.
The manufacturer CANNOT solve problems caused by
using batteries and battery chargers that were not di-
rectly supplied.
10.

CONDITIONS OF WARRANTY

All our appliances are subjected to rigorous tests and
are covered by warranty against material or manufac-
turing defects for a period of 12 months. The warranty
comes into effect from the date of purchase. The date of
purchase is the date indicated on the receipt issued by
the Reseller when the appliance is consigned. The man-
ufacturer shall repair or replace any faulty parts free of
charge during the period covered by the warranty. Any
defects, which cannot be clearly attributed to material
or manufacturing defects shall be examined by one of
our Technical Service Centres or at our factory and
charged in accordance with the outcome. The follow-
ing are anyhow not covered by the warranty: accidental
damage during transportation or handling, accidental
damage caused by negligence or unsuitable conduct,
damage due to incorrect or improper uses or installa-
tions which do not conform with the warnings included
in the instruction manual, and anyhow due to unusual
events which do not depend on the running or use of
the appliance. Appliances requiring repair must be de-
livered at the Technical Service Centre complete with
all their original accessories together with proof of pur-
chase. If the appliance has been repaired or tampered
with by unauthorised third parties, the warranty shall
be considered null and void. The warranty shall also be
considered null and void if the user is not able to pro-
duce an original (legible and complete) document prov-
ing purchase or if it not possible to read the appliance
serial number located on the frame. The appliance shall
not be replaced and the warranty shall not be extended
once the appliance has been affected by a fault. Repairs
shall be carried out at one of our Authorised technical
Service Centres or at our factory. Appliances for repair
must be sent carriage free, that is, the user shall pay and
be responsible for carriage. The warranty does not cover
the cleaning of working parts, any scheduled mainte-
nance nor the repair or replacement of parts subject
to normal wear and tear. The manufacturer shall not be
held liable for damage to persons or things caused by
any installation which does not comply with the instruc-
tions in the manual or faulty use of the appliance.

10.1 SCRAPPING OF THE MACHINE

If the machine will no longer be used, remove the bat-
teries and dispose of them in accordance with the
eco-compatibility regulations as set forth in European
39