Insufficient Suction; The Brush Motor Or The Suction Motor Doesn't Stop; The Squeegee Doesn't Clean Or Dry Efficiently; The Battery Charger Doesn't Work - Comet CPS 55 BT Bedienungsanleitung

as required.
 The detergent feed conduit is clogged in some
point.
 Clean out the conduit by removing the dirt.
8.5. NO SUCTION
 The suction hose is not connected to the squeegee.
 Connect it correctly.
 The suction hose or the squeegee conduit are clogged.
 Clean out and remove any obstructions from the
conduits.
 The suction motor is turned off.
 Activate it.
 The recovery tank is full.
 Empty it.
 The suction motor is not receiving electric power
or is burned.
 Check the connections and, for the latter case,
replace the motor.

9.5 INSUFFICIENT SUCTION

 The recovery tank cover was not correctly tightened.
 Tighten it correctly.
 The recovery tank drain hose plug is not perfectly
closed.
 Close it correctly.
 The suction hose, the squeegee conduit or the
inspection compartment is clogged.
 Clean out and remove any obstructions from the
conduits.
8.6. THE BRUSH MOTOR OR THE SUCTION
MOTOR DOESN'T STOP
 Stop the machine, cutting off the main power sup-
ply and disconnecting the main battery connector,
and contact the technical service centre.
8.7. THE SQUEEGEE DOESN'T CLEAN OR DRY
EFFICIENTLY
 The squeegee blades are worn or are dragging so-
lid dirt.
 Replace or clean them.
 The squeegee adjustment is not correct; the
advancement must be exactly perpendicular to the
running direction.
 Adjust the squeegee.
 The suction hose or the squeegee conduit are clogged.
 Clean out and remove any obstructions from the
conduits.
8.8.

THE BATTERY CHARGER DOESN'T WORK

 The battery charge doesn't start.
 Check that the battery charger is connected to the
battery. Consult the battery charger manual.
8.9. THE BATTERIES DO NOT CHARGE OR DO
NOT HOLD A CHARGE
 At the end of the charging process, the battery is
not correctly charged (see the battery manufacturer's
instruction-maintenance manual)
 Check the battery charger error message and
check the data indicated on the display (see the bat-
tery charger's instruction manual).
 The batteries are new and do not generate 100% of
the rated performances.
 The accumulator reaches the maximum perfor-
mance after 20-30 complete charge cycles.
 The electrolyte has evaporated and does not com-
pletely cover the plates.
 Check the battery manufacturer's use and mainte-
nance manual.
 There are significant differences in density among
the various elements.
 Replace the damaged battery.
Always consult the battery and battery charger use and
maintenance manual. If this does not solve the pro-
blem, contact the authorised technical service centre.
The manufacturer CANNOT solve problems cau-
sed by using batteries and battery chargers that
were not directly supplied.
9.

CONDITIONS OF WARRANTY

All our appliances are subjected to rigorous tests and
are covered by warranty against material or manufac-
turing defects for a period of 12 months. The warranty
comes into effect from the date of purchase. The date
of purchase is the date indicated on the receipt issued
by the Reseller when the appliance is consigned. The
manufacturer shall repair or replace any faulty parts
free of charge during the period covered by the war-
ranty. Any defects, which cannot be clearly attributed
to material or manufacturing defects shall be exam-
ined by one of our Technical Service Centres or at our
factory and charged in accordance with the outcome.
The following are anyhow not covered by the warranty:
accidental damage during transportation or handling,
accidental damage caused by negligence or unsuitable
conduct, damage due to incorrect or improper uses or
installations which do not conform with the warnings
included in the instruction manual, and anyhow due to
unusual events which do not depend on the running
or use of the appliance. Appliances requiring repair
must be delivered at the Technical Service Centre com-
plete with all their original accessories together with
proof of purchase. If the appliance has been repaired
or tampered with by unauthorised third parties, the
warranty shall be considered null and void. The warran-
ty shall also be considered null and void if the user is
not able to produce an original (legible and complete)
document proving purchase or if it not possible to read
the appliance serial number located on the frame. The
appliance shall not be replaced and the warranty shall
not be extended once the appliance has been affect-
ed by a fault. Repairs shall be carried out at one of our
36