Casualplay Baby Zero Plus Anweisungen Seite 24

Installing the Baby Zero PLUS
WARNING: Do not install the child restraint system on front seats fitted with a
frontal AIRBAG, without disconnecting it first.
• The Baby Zero Plus must always be fitted facing backwards, with the child facing the
back of the car (fig.13).
• Position the Baby Zero Plus on the vehicle seat so that the child is facing the back of
the car.
• Put the handle in the installing in the car position and make sure that it clicks into place
when it reaches the position.
• Pull, carefully, the seat belt and pass it over the Baby Zero Plus. The abdominal must go
under the handle. Fasten the seat belt, and pass the abdominal part of the belt through
the two corresponding guides (1) (coloured blue) (fig.14).
• Pass the diagonal part of the belt behind the Baby Zero Plus (fig.15).
• Put the belt in the corresponding guide (coloured blue). Hold the Baby Zero Plus firmly
and pull the diagonal part of the belt to tighten it (fig.16).
Removing the Baby Zero Plus
• Take the diagonal part of the belt out of the fork (coloured blue).
• Unfasten the belt and take it out of the guides of the abdominal part taking care to keep
the belt away from the child.
• Before taking the Baby Zero Plus out of the car, move the handle to the carrying position.
Make sure that the handle clicks locked into place.
Installing the BABY ZERO PLUS on the BASE FIX BABY ZERO PLUS
NOTE: The Baby Zero Plus (depending on the model) can be installed in the
vehicle using the Base fix Baby Zero Plus, which is sold separately.
NOTE: Before purchasing the Base fix Baby Zero Plus check that your Baby Zero
Plus is fitted with the release device found on the backrest.
• Set the handle of the Baby Zero Plus to the carrying position (fig.5) (C).
• Position the Baby Zero Plus facing backwards, place it on the fastening points of the
base.
• Press the Baby Zero Plus against the base, you will hear it click and two green indicators
will appear on the front part of the base (fig.17).
• Check that it is correctly fastened onto the base by pulling the Baby Zero Plus
upwards.
22