Herunterladen Inhalt Inhalt Diese Seite drucken

Units Installation; Initial Check; Installation Place - Hitachi HRNM Serie Installations- Und Betriebshandbuch

Dc inverter
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 89

UNITS INSTALLATION

16
11. UNITS INSTALLATION

11.1. INITIAL CHECK:

Factory supply accessories
Accessory
Pipe with flange of refrigarant piping
Compressed sheet
NOTE:
If any of these accessories are not packed with the
unit, please contact your contractor.

Installation Place

Install the outdoor unit in a place where there is adequate
space around the unit for operating and maintenance as
shown below.
Install the outdoor unit where a good ventilation is available.
Install the outdoor unit where it is in the shade or it will not
be exposed to direct sunshine or direct radiation from high
temperature heat source.
Install the outdoor unit where the falling ice from the unit will
not create a hazard, as in the case of installation on top of a
building where ice may fall down on the pedestrians.
Install the outdoor unit where the sound or discharge air from
the outdoor unit does not affect neighbors or environment.
Check to ensure that the foundation is flat and sufficiently
strong.
Do not install the outdoor unit where dust or other
contamination could block the outdoor heat exchanger.
When installing the outdoor unit in snow-covered areas,
mount the field-supplied hoods on the top of the outdoor unit
and the inlet side of the heat exchanger.
Do not install the outdoor unit where there are high-levels of
oil mist, salty air or aggressive gases such as sulfur.
Do not install the outdoor unit where electromagnetic waves
are directly radiated to the electrical box and inverter
components.
Install the outdoor unit as far as practical at least 3 meters
from the electromagnetic wave radiation, as electronic noise
can cause miss-operation of the unit.
Q'ty
1
1
NOTE:
In certain cases, a fuse may be blown and the system
my stop in high electro-magnetic turbulence
environment.
In certain cases, the system can get an alarm in high
electro-magnetic turbulence environment. In such
case, stop and start the system to clear the alarm.
CAUTION:
Aluminum fins have very sharp edges. Pay attention
to the fins to avoid any injury.
NOTE:
Install the unit in a restricted area not accessible by
the general public.

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis