Hitachi HRNM Serie Installations- Und Betriebshandbuch Seite 96

BETRIEB MIT FERNBEDIENUNG
8
5.1.6. TIMER OPERATION PROCEDURE
Setting current day and time
1. Hold down the DAY switch for more than 3 seconds to change to current day setting
mode. SET is indicated and the day blinks. All the days except the current day are
indicated.
2. Press DAY switch until the actual day flickers, then press OK switch.
Selected day is indicated and "time" flickers.
3. Press the SELECT switch to adjust the "hour" setting, and then press again. "Hour" is
indicated and "minutes" flickers.
4. Press switch to adjust "minutes", and when adjusted press OK switch. The current time
setting mode ends and returns to normal mode. "Minutes" is indicated and SET is lighted
off. "Seconds" starts from zero.
Setting the timer (programming)
1. Press the TIMER switch. SET and SCHEDULE are indicated. Schedule Number "1" flickers
and other numbers are indicated.
2. When the schedule switch is pressed , el número de programa se desplaza
[1] [2] [3] [4] [S]
- Select [S] to set the ON/OFF time and temperature shifts.
- *By pressing TIMER switch, SET and SCHEDULE are lighted off and changed to normal
mode.
3. When the OK switch is pressed, the selected schedule number is indicated. Other
schedule number are lighted off, and "Hour" of ON time for the selected schedule Number
flickers.
4. Press the SELECT to adjust the "minutes" setting, and then press again. "Hour" is
indicated and "minutes" flickers.
5. Press the SELECT switch to adjust the "minutes" setting, and then press again.
"Minutes" is indicated and "hour" of OFF time flickers.
6. Set the OFF time the same way as the ON time. After setting "minutes", OFF time is
indicated. If the schedule number [1][2][3][4] is selected, the indication changes to set the
schedule number shown in 2. If [S] is selected, see the section on setting temperature
shifts for details.
7. When the TIMER switch is pressed, the SET and SCHEDULE indicators go out and the
mode returns to normal.
[1] ....