•
Installing the drain fitting
□
Slip first the narrow sealing ring
the eccentric nut
23
eccentric rod
. The narrow sealing ring must
25
be between the eccentric nut and the ball.
□
Slip the eccentric connection
clamping plate
back onto the longer part of
24
the eccentric rod. The clamping plate fixes the
position of the eccentric connection.
□
Unscrew the upper part
□
Remove the lower drain seal
□
Insert the upper part of the drain fitting, with the
upper drain seal
15
□
Screw on the lower part
with the lower drain seal, under the washbasin
until finger-tight and make sure that the thread-
ed flange
is pointing towards the back.
18
□
Insert the shorter part of the eccentric rod, with
the ball
, into the threaded flange so that
21
the eccentric rod reaches the bottom end of the
adjusting screw
in the opening.
12
□
Screw the eccentric nut, with the narrow sealing
ring, onto the threaded flange.
□
Insert the upper part
the corresponding hole in the tap body
□
Insert the lower part
the eccentric connection.
□
Screw the two parts of the pull rod together.
□
Fix the lower part of the pull rod to the eccentric
connection by screwing the Phillips-head screw
tight.
□
Check that the drain fitting works properly.
□
If necessary, adjust the position of the eccentric
connection on the lower part of the pull rod
by loosening the Phillips-head screw a few
turns and tightening it again after making the
adjustment.
□
Once successfully installed, turn on the hot and
cold water supply.
and then
22
onto the longer part of the
and the
26
of the drain fitting.
14
.
16
, into the washbasin drain.
of the drain fitting,
17
of the pull rod through
29
.
6
of the pull rod through
28
•
First use
Make sure to carefully check that all connections
are leak-tight after the first use.
The tap must be flushed to remove any impurities
before using it for the first time.
To do this, follow the steps below:
□
Unscrew the aerator
tap outlet spout
(see "Maintenance and
4
cleaning" section).
□
Turn on the main water supply and let the water
run for two minutes to remove residue.
□
Finally, screw the aerator clockwise back onto
the tap outlet spout.
•
Operation
□
Tilt the tap lever
1
wards to regulate the strength of the water flow.
□
Turn the tap lever clockwise or anticlockwise to
regulate the temperature of the water flow:
For cold water, turn the tap lever anticlockwise
(to the right).
For hot water, turn the tap lever clockwise (to
the left).
•
Maintenance and cleaning
CAUTION! RISK OF DAMAGE! Follow
■
the instructions below on how to properly clean
and maintain the tap to avoid damage. Never
use petrol, solvents, harsh cleaning products
or hard brushes for cleaning, as these could
damage the surface of the tap.
•
Cleaning the tap
□
Dry your taps with a cloth after every use to
prevent the build-up of limescale.
□
Wipe the tap clean with a soft, damp cloth and
a mild detergent if necessary.
□
Unscrew the aerator
spout
at regular intervals and remove any hard
4
residue or foreign bodies. If the aerator is very dirty
or damaged, replace it with a new one.
Note: You should be able to unscrew the
aerator by hand. If this is not possible, protect
the aerator by wrapping it in a thin, damp cloth
and carefully unscrew it using a pipe wrench.
First use
anticlockwise from the
5
upwards or push it down-
from the tap outlet
5
GB/CY
9