The Bass Boost Function; Operating The Radio; Operating The Cd Player; Starting Playback - Silvercrest KH 2305 Bedienungsanleitung

loudspeakers are disconnected and you will only hear sound
via the headphones.
Important! Listening to music with headphones for
long periods and at high volume levels can lead to
hearing damage!

The Bass Boost function

When you want to emphasize the deep frequencies during
playback press the BASS BOOST r button. To deactivate the
function press the button again.

Operating the radio

This device receives radio stations on the frequency bands,
Ultra short wave (USW or engl. FM) and Medium wave (MW
or engl. AM).
The technical details of the device allow for an adjustable fre-
quency range of MW (AM) 526,5 - 1606,5 kHz, and/or FM
(USW) 87,5 - 108 MHz. In some countries, different national
regulations may apply to the assigned radio frequency ranges.
Please note that information received outside of the assigned
radio frequency ranges may not be used, passed on to third
parties or otherwise misused.
> In order to receive a good USW reception with the micro
system unwind the dipole antenna 3) on the rear panel of
the device completely.
> If the reception is insufficient change the position of the
dipole antenna 3). Secure the dipole antenna 3), if neces-
sary, with sticky tape.
> The device has a built in ferrite antenna for reception of
MW stations. When the MW reception is insufficient please
turn the device in a more favourable direction.
> To activate the radio function move the FUNCTION switch
2@ to the "RADIO" position.
> Now select with the BAND switch
cy band FM or AM depending on which band the station
that you want to hear is located. If the switch is in the posi-
tion FM ST, the appliance plays the VHF station in stereo.
> With the aid of the TUNING controller
select the station. For this turn the controller in a clockwise
direction to select stations with a higher broadcast frequen-
cy than the one currently shown in the display y.
> Turn the TUNING controller
rection to select stations with a lower broadcast frequency
than the one currently shown in the display y.
> When the device receives stereo USW transmissions, in the
display y the symbol lights up.
> If the stereo reception becomes noisy move the BAND-
switch a to the FM position and thus switch to mono.

Operating the CD player

The device plays audio CDs (CD-A) and MP3-CDs. Both
pressed and blank discs burnt on the computer of the format
CD-R and CD-RW are supported. Because of the many differ-
ent kinds of blank discs, computer types, operating systems,
1) the desired frequen-
u you can now
u in a counter clockwise di-
burning software and burning processes we are not able
to guarantee that every "burnt" disc will playback faultlessly.
Inserting a CD
> Move the FUNCTION switch
tion.
> To open the CD tray
spot w of the CD tray lid. The lid will open.
> Place the CD with the marked side up pointing towards
the arbor of the CD disc in the CD tray q.
> Press the CD lightly downwards until it locks firmly onto
the arbor.
> To close the CD tray
and carefully press on the " " marked spot w until the lid
locks into place.
The device will now read the CD. Subsequently the display y
shows the number of CD titles.

Starting playback

> Press the button 4; 2$ on the device and/or the button
PLAY/PAUSE 4$ on the remote control.
4;
The display y shows you the number of the currently playing
back title, the playback symbol 4 as well as "DISC".
Playback stop/resume
> During playback press the button
and/or the button
4;
trol to stop playback. When CD playback is stopped the
playback symbol 4 blinks in the display y.
> To resume playback press the button
PLAY/PAUSE 4$ again.

Next/previous title

> To playback the next title of a CD press the button
on the device and/or the SKIP + button 3( on the remote
control.
> To playback the previous title of a CD briefly press twice
successively the button 9 o on the device and/or the
SKIP — button 4# on the remote control.
Search forward and backward
You can activate a search to look for specific passages within
a title.
> For this, during playback, hold down the button
or SKIP + 3( (forwards) or the button 9 o and/or SKIP
— 4# (backwards) until the desired location in the title is
reached.
Stopping the play function
> Press the button < 2# on the device and/or STOP < 3*
on the remote control.
Removing the CD
> To open the CD tray
spot w of the CD tray lid. The lid will open.
> Remove the CD.
> To close the CD tray
and carefully press on the " " marked spot w until the lid
locks into place.
Switching on the repeat function
With the repeat function you can repeat play individual titles or
all the titles of a CD.
- 35 -
2@ to the CD/MP3/USB posi-
q carefully press on the " " marked
q push the lid, by hand, downwards
2$ on the device
4;
PLAY/PAUSE 4$ on the remote con-
4;
2$ and/or
q carefully press on the " " marked
q push the lid, by hand, downwards
4;
: i
: i and/