Select Modes; Adjust The Bass; Adjust The Volume; Volume Memory - Silvercrest SBMS 30 A1 Bedienungs- Und Sicherheitshinweise

Press /
6 20
ON .
Press /
6 20
back to STANDBY mode .
Disconnect the power cord
outlet socket if you want to switch off the
product completely .
NOTES:
When turning the product on, the product
will continue in the mode it was in when it
was last turned off .
When there is no input signal (or weak
input signal) in AUX / BLUETOOTH / USB
modes and when no CD is being played
(No disc, Stop or Pause) for over 15 minutes,
the product will automatically switch to
STANDBY mode .
˜ Select modes
To get to the desired function mode, press
SOURCE repeatedly or press CD, USB,
7
TUNER, AUX or BT
21
mode .
˜ Adjust the bass
Press BASS +/–
repeatedly to select a preset
39
sound effect: Bass 0, Bass 1, Bass 2 .
˜ Adjust the volume
Press VOL +/–
43
control to adjust the volume .
2
To turn the sound off, press
again or press VOL +/–
Press
VOL+ / VOL– control
volume .
˜ Volume memory
The last used volume level will be
automatically stored .
˜ Select the equaliser
Press EQ
/
13 40
[POP] – [CLASSIC] – [ROCK] –
[JAZZ] – [FLAT] .
to switch the main unit
to switch the main product
from the wall
46
to select the desired
or turn VOL+ / VOL–
.
41
or turn
43
to resume normal
2
repeatedly to select:
˜ Adjust the brightness
Press DIMMER
35
level .
˜ Set the clock
Setting of the clock can only be done in STANDBY
mode .
In STANDBY mode, press and hold
CLOCK
until the hour digits are flashing .
32
Press , to adjust the hour digits . Press
27
CLOCK
to confirm . The minute digits are
32
flashing .
Press , to adjust the minute digits .
27
Press CLOCK
32
NOTE: Each activated state will be cleared
if any buttons are not pressed within
20 seconds .
Toggling between 12/24 hour formats:
During time setup, press
NOTE: If the product is unplugged or if
a power failure occurs, all setups of the
product will be erased .
Time display
Press CLOCK
to show the current time on the
32
display for a few seconds .
˜ Set the alarm timer
NOTE: The clock must be correctly set for
the timer to operate correctly .
In STANDBY mode, press and hold
TIMER
until the hour digits flash on the
38
display .
Press , to adjust the hour digits . Press
27
TIMER
to confirm . The minute digits will
38
flash on the display .
Press , to adjust the minute digits .
27
Press TIMER
38
flashes on the display .
to select the brightness
to confirm .
or .
15 42
to confirm . BUZZER
GB/IE 31