Select Modes; Adjust The Bass; Adjust The Volume; Volume Memory - Silvercrest SBMS D30 B1 Bedienungs- Und Sicherheitshinweise

NOTES:
When turning the product on, the product
will continue in the mode it was in when it
was last turned off .
To save energy the product will
automatically switch to standby mode when
there is no input signal (or only a weak one),
and when the CD player is not in use .
˜ Select modes
To get to the desired function mode, press
SOURCE 7 repeatedly or press CD, USB,
TUNER / DAB, AUX or BT 21 to select the
desired mode .
˜ Adjust the bass
Press BASS +/– 39 repeatedly to select a preset
sound effect: Bass 0, Bass 1, Bass 2 .
˜ Adjust the volume
Press VOL +/– 43 or turn VOL+ / VOL–
control 2 to adjust the volume .
To turn the sound off, press
again or press VOL +/– 43 or turn
Press
VOL+ / VOL– control 2 to resume normal
volume .
˜ Volume memory
The last used volume level will be
automatically stored .
˜ Select the equaliser
Press EQ 13 / 40 repeatedly to select:
[POP] – [CLASSIC] – [ROCK] –
[JAZZ] – [FLAT] .
˜ Adjust the brightness
Press DIMMER 35 to select the brightness
level .
˜ Set the clock
Setting of the clock can only be done in STANDBY
mode .
In STANDBY mode, press and hold
CLOCK 32 until the hour digits are flashing .
Press , 27 to adjust the hour digits . Press
CLOCK 32 to confirm . The minute digits are
flashing .
32 GB/IE
Time display
Press CLOCK 32 to show the current time on the
display for a few seconds .
˜ Set the alarm timer
41 .
Press , 27 to adjust the minute digits .
Press CLOCK 32 to confirm .
NOTE: Each activated state will be cleared
if any buttons are not pressed within
20 seconds .
Toggling between 12/24 hour formats:
During time setup, press
NOTE: If the product is unplugged or if
a power failure occurs, all setups of the
product will be erased .
NOTE: While the DAB mode is selected, the
clock is set automatically .
NOTE: The clock must be correctly set for
the timer to operate correctly .
In STANDBY mode, press and hold
TIMER 38 until the hour digits flash on the
display .
Press , 27 to adjust the hour digits . Press
TIMER 38 to confirm . The minute digits will
flash on the display .
Press , 27 to adjust the minute digits .
Press TIMER 38 to confirm . BUZZER
flashes on the display .
Press , 27 to select
FM / DAB / CD / USB / BUZZ mode . Press
TIMER 38 to confirm . The display will show
the volume level .
Press , 27 to adjust the volume . Press
TIMER 38 to confirm .
Short press Description
TIMER 38
1x Timer on
2x Timer off
NOTE: The operating time to set each step
must not take longer than 20 seconds or it
will return to time display .
or 42 .
15
Display
–