Prepare The Remote Control; First-Time Use; Replace The Remote Control Battery (Fig . A); Placing Tv Or Monitor - Silvercrest SBS 60 B2 Bedienungs- Und Sicherheitshinweise

˜ Prepare the remote control
The provided remote control allows the product to
be operated from a distance .
Even if the remote control is operated within
the effective range (6 m), remote control
operation may be impossible if there are
any obstacles between the product and the
remote control .
If the remote control is operated near other
products which generate infrared rays, or if
other remote control devices using infra-
red rays are used near the product, it may
operate incorrectly . Conversely, the other
products may operate incorrectly .
˜ First-time use
The remote control has a pre-installed lithium
CR2025 battery . Remove the protective tab to
activate the remote control battery .
˜ Replace the remote control
battery (Fig. A)
Pull out the battery tray
old battery .
Place a new CR2025 battery into the battery
tray with correct polarity (+/–) as
23
indicated .
Insert the battery tray
DANGER OF EXPLOSION! If
the battery is not correctly
replaced . Replace only with the
same or an equivalent type .
WARNING!
Ensure the correct polarity of
the battery . The plus symbol on the battery
must be visible (see fig . A) .
and remove the
23
back into the slot .
23
˜ Placing TV or monitor
Note: Ensure the TV is positioned properly .
Turning the volume up too loud may cause the TV
to vibrate and fall over .
This product is designed for use with TVs
and similar display devices up to a maximum
dimension of the base stand of 48 cm (W) x
22 cm (D) and within a maximum load of
35 kg . The base stand shall spread the
weight across a reasonably wide area of the
product .
The soundbase is NOT suitable for use with
heavy display devices that use narrow legs
instead of a large base stand, as these type
of feet may concentrate excessive force onto
the soundbase .
Place the device on a level and stable
surface .
Note: Furniture cleaning products may affect
the soundbase's rubber stands . If in doubt,
use a pad . Use a mat if in doubt .
Decide where to place the product .
Always make sure that ...
- there is a wall socket nearby;
- there is enough space above, in case you
want to place a television set on the device;
- a television set and any other devices
(e . g . set-top box, DVD player) can be set
up nearby, in case you do not want / are
unable to place them on the device .
Connect the source device(s) . Always ensure
that all devices are securely positioned .
GB 11