Setting The Device; The Operational Controls - Silvercrest KH 2305 Bedienungsanleitung

Risk of fire!
• Do not use the device in the vicinity of hot surfaces.
• Do not place the device in locations that are subject to
direct sunlight. Otherwise, it may overheat and become
irreparably damaged.
• Never leave the device unattended while it is being used.
• Never cover the ventilation slots of the device while it is on.
Avoid placing this device in locations that provide insuf-
ficient ventilation or hot locations and do not place the de-
vice in direct sunlight or under strong artificial light sources.
• Do not place any open sources of fire, like candles, on the
device.
• When a storm and/or thunderstorm with the risk of lighten-
ing threatens please disconnect the device from the mains
power.
Risk of personal injury!
• Keep the power cord and device away from children.
Children frequently underestimate the dangers of electrical
equipment.
• Ensure a safe location for the device.
• Do not operate the device if it has sustained a fall or is
damaged. Arrange for the device to be checked and/or
repaired by qualified technicians.
• Batteries should not be allowed to fall into the hands of chil-
dren. Children can put batteries into their mouths and swal-
low them. If a battery is swallowed medical assistance must
be sought immediately.
• This device is not intended for use by individuals (including
children) with restricted physical, physiological or intellectu-
al abilities or deficiencies in experience and/or knowledge
unless they are supervised by a person responsible for their
safety or receive from this person instruction in how the de-
vice is to be used. Children should be supervised to ensure
that they do not play with the device.
Danger of eye injuries!
• The device is fitted with a "Class 1 Laser". Never look di-
rectly into an open CD tray The invisible laser beam could
damage your eyes.
CAUTION!
Information on surge voltage (EFT / rapid electrical
transition process) and Electrostatic discharge:
In the case of a misfunction due to rapid electrical transition
(surge voltage) or electrostatic discharge the product must be
reset (it may be necessary to disconnect the power source and
then reconnect it) to restore normal operation.
Note: A case of electrostatic discharge occurs if one walks
with plastic-soled shoes over a carpet that also contains ele-
ments of plastic. Through the friction of the shoe soles on
the carpet a charge is created in the body which discharges
itself as soon as one touches an electricity conducting object,
such as for example a door knob or the bodywork of a motor
vehicle. Thereby it is sufficient to approach the conductor to
within only a few cm. Direct contact is not required to effect a
discharge. The charge can also unload itself over an electrical
arc. A discharge is thus also possible through plastic housing
components.
Note: This device is equipped with non-slip rubber feet.
As upper surfaces can comprise of various materials and are
treated with various cleaning materials, it cannot be completely
excluded that some of these materials contain components that
could attack and soften the rubber feet. If possible place an
anti-slip material under the feet of the device.
Observe copyright laws
When recording CDs, cassettes or radio transmissions observe
the copyright laws of the country, in which the device is to be
used.

Setting the device

> Remove the micro system and accessories from the packing.
> Remove all transportation fasteners and tapes/foils.
> Place the micro system on an even, level surface. Place the
micro system in such a position that the CD tray cover q
can open fully.
> Place the speakers to the right and left of the micro system.

The operational controls

On the device
q CD compartment
w
e Infrared sensor for the remote control signal
r BASS BOOST
t PROGRAM
y Display
u TUNING
i :
9
o
a BAND
s Cassette compartment cover viewing window
d Cassette compartment cover
f Protective flap for the cassette player/recorder keys
g ;
h
j 8
k 7
l 4
1( =
2) PHONES
2!
2@ FUNCTION
<
2#
4;
2$
2% VOL —
2^ VOL +
2& CD/MP3/USB
2* POWER
2( Speaker box
3) FM (USW) dipole antenna
3! Power switch
3@ Speaker connection LEFT +
3# Speaker connection LEFT —
3$ Speaker connection RIGHT —
3% Speaker connection RIGHT +
3^ Power cord
- 33 -
- CD pressure point - Tray open /
close
- To emphasis the deep frequencies
- For the saving of CD programmes
- Station tuning
- CD title skip forwards
- CD title skip backwards
- Radio band switching,
USW mono/stereo switching
- Stop cassette playback
- End cassette playback
Open cassette compartment
- Cassette wind forward
- Cassette wind backwards
- Start cassette playback
- Start cassette recording
- Headphones socket
- USB port
- Select programme source
On/Off switch
- CD playback end
- CD playback start/stop
- Reduce volume
- Increase volume
- Switching between CD/USB
playback
- Operation indicator