Equalizer; Bass Function; Display Brightness; Sleep Timer - Silvercrest 279334 Bedienungsanleitung

9.12. Equalizer

The Micro Stereo System has an equalizer with the following preset sound modes: "Pop",
"Classic", "Jazz" and "Rock".
During playback, press the EQ button [12] on the Micro Stereo System or the EQ button [38]
on the remote control to toggle between the different equalizer settings. The currently set sound
mode is shown on the display [2]. If no sound mode is shown, the sound is played back
unchanged.

9.13. Bass function

Press the BASS button [40] on the remote control during playback to amplify the bass sound.
Press the BASS button [40] on the remote control again to play the sound unchanged. When
toggling, "BASS ON" or "BASS OFF" is briefly shown on the display [2]. While the bass function
is enabled, "Bass" reads permanently on the display [2].

9.14. Display brightness

Press the DIMMER button [15] on the Micro Stereo System or the DIMMER button [53] on
the remote control multiple times to adjust the display [2] brightness step by step.

9.15. Sleep timer

The sleep timer powers the device off automatically after a set time. The sleep timer is available in
all operating modes. Proceed as follows to use the sleep timer:

During playback, press the SLEEP button [45] on the remote control multiple times to toggle
between the power off delay times. The following options are available: "SLEEP 90", "SLEEP
60", "SLEEP 30", "SLEEP 15" and "SLEEP 00". The digit indicates the minutes before power
off. "SLEEP 00" will disable the sleep timer.

Stop pressing the button when the desired option is shown. After a few seconds, the selection
option disappears from the display [2] and is enabled.

While the sleep timer is enabled, press the SLEEP button [45] on the remote control once to
show the remaining power off delay time.
SilverCrest SMBC 30 A1
English - 51