GOLDONI 3070V Star Bedienung Und Instandhaltung Seite 83

- Clogging gauge of the engine air filter
Check that the clogging gauge of the engine air filter is in the correct position
and, if it is serviced, make sure that it is correctly assembled and protected
against the outdoor weather conditions as indicated in fig. 28.
It is essential for the cable connecting to the electrical system of the machine N°
1 fig. 28 to come out of the lower part of the actual gauge itself. The engine air
intake circuit could be seriously damaged if the protection is installed in the
wrong position.
- Fuses:
Before a fuse is replaced, repair the fault that has caused the short-circuit. The
fuses protect the following parts (fig.26):
.
A = Differential lock switch power supply, 4WD engaging switch (10A)
B = Power supply for parking brake switch (Brake light), hazard light switch +15
(15A)
C= Right front / rear left side lights, 8-way male connector for the cab connector,
7-pin socket (10A)
D= Left front/rear right side lights, license plate light, 8-way male connector for
the cab connector, dashboard lighting, 7-pin socket connector (10A)
E= Alternator, motor-stop solenoid valve power supply, power take-off switch,
dashboard (7.5A)
F = 8-way male connector for the cab connector power supply, 7-pin socket
(10A)
G = Left dipped beam (7.5A)
H = Right dipped beam (7.5A)
I = Optional (20A)
L = Horn, main beam blinker power supply (10A)
M= Hazard light switch +30, 8-way male connector for the cab connector (15A)
N= Left and right main beams and main beam indicator light (15A)
The tractor is equipped with two 60A main fuses for the tractor harness and 30A
for the cab harness. They are installed in the front right hand part behind the
fixed dashboard support.
82