Working With The Appliance - Silvercrest SPM 6200 A1 Bedienungsanleitung

WARNING - RISK OF INJURY
At too high speeds and with a too heavy pressure, the sapphire
miller can quickly penetrate into deeper, healthy skin layers.
This can cause injury and damage to the periosteum!
► Always take care and a cautious approach when removing corns. If in
doubt, consult a pedicurist, podolgist or a dermatologist.
To remove corns, mill very carefully and slowly at low speed with the round
sapphire cutter w.
Under no circumstance should you use undue pressure, otherwise you could rapidly
penetrate healthy skin and injure it.

Working with the appliance

WARNING - RISK OF INJURY
Too long and too intensive treatment can also injure deeper
layers of skin.
► Therefore regularly check the treatment progress and results. Diabetics in
particular are less sensitive on the hands and feet.
NOTICE
► The attachments show only a reduced eff ect with softened skin. Therefore do
not carry out any pretreatment in a water bath before using the appliance.
1) Find a well-lit place to work. A mains power outlet must be positioned in close
proximity.
2) Insert the appropriate attachment for your purpose in the attachment accep-
tor 1. The attachment must sit securely.
3) Insert the power adapter
4) Slide the on/off /direction switch
runs with the lowest speed.
NOTICE
► Always select the direction of run so that you can treat the nails in their di-
rection of growth. Where possible, treat the nails from the outside towards
the inside (to the nail tip). Otherwise, the nails split more easily.
► If you feel that the nails could tear during treatment, select the other direc-
tion of run.
SMP 6200 A1
4 into a mains power outlet.
6 into the desired direction. The appliance
GB
IE
CY
9