Silvercrest SPM 6200 A1 Bedienungsanleitung Seite 12

GB
IE
CY
10
5) Always start the treatment at low speed and increase it only when needed.
When you wish to increase the speed, press the "Speed increase" 2 button.
When you wish to decrease the speed, press the "Speed decrease" 3 button.
6) You can now begin with the task.
WARNING - RISK OF BURNS
Risk due to severe heat development!
While you are working, never let the attachments rest on one point.
Due to friction this leads to increased heat generation and may cause injury.
► Always work in a circular motion.
ATTENTION - PROPERTY DAMAGE
Risk due to overheating!
If you use the appliance for more than 15 minutes at a time, the motor may
overheat.
► After 15 minutes of operation take an approx. 30 minute break so that the
motor can cool down.
7) Place the on/off /direction switch
from the mains power socket when you have fi nished the treatment.
NOTICE
► If you have treated callouses, after completing the procedure apply a
moisturising cream to the treated areas.
6 at "•" and remove the power adapter 4
SMP 6200 A1