Maintenance - Cembre B1350L-C Bedienungsanleitung

Do not apply pressure to or stab at the touch button, a light touch using a bare
BATTERY 
finger is sufficient. The command pulse is sent when the finger releases the button.
2.8) Battery status
The battery is equipped with LED indicators that indicate the remaining battery life at
BATTERY
any time by pressing the adjacent button (P) (Ref. to Fig. 5):
4 LEDs illuminated: fully charged
2 LEDs illuminated: 50 % capacity
1 LED flashing: minimum charge, replace the battery.
With the battery inserted into the tool, the remai-
ning battery life can also be checked on the display,
RESET
via touch button selection (Ref. to § 4).
SW:S1J41AH
The screen shown alongside indicates that the battery
Vage has dropped below a minimum safety threshold;
under these conditions the tool will not start, and it is
necessary to recharge or replace the battery.
The approximate time to fully recharge a battery is about 80 minutes.
LED
N
OFF
After each working cycle, and after the extraction of the battery from the
tool, an integrated battery cut-off device will operate after 70 s approx.
3 SEC.
LED
Then the LED nearest to button (P) will flash 5 times each 14 s approx. The battery will
ON
n
be reactivated when it is reintroduced into the tool and the operating button is pressed.
n
2.9) Using the battery charger
Carefully follow the instructions in the battery charger user manual.
r

3. MAINTENANCE

si
The tool is robust, completely sealed, and requires very little daily maintenance. Compli-
i
ance with the following points, should help to maintain its optimum performance:
3.1) Thorough cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth taking care to remove any
residue, especially close to pivots and moveable parts.
Do not use hydrocarbons to clean the rubber parts.
3.2) Storage case
When not in use, the tool should be stored and transported in the plastic case, to prevent
damage. The case, type VAL P36, is suitable for storing the tool, the accessories and up to
7 die sets and pre-prepared compression connectors.
VAL P36: Size 500x480x128 mm (19.7x18.9x5.0 inches). Weight 3,1 kg (6.8 lbs).
5
9

F = 125.2 kN
m
Fp = 94.5 kN
13001


F = 14.07 ton
m
Fp = 10.61 ton
F = 125.2 kN
m
P = 692 bar
m
F = 102.3 kN
p
Pp = 522.3 bar
P = 692 bar
m
P = 565 bar
p
P = 10037 psi
m
Pp = 7575 psi
max.
BATTERY
BATTERY
1000
-12000
B1350 LED
NR 13AB485
ON
LED
OFF
3 SEC.

ERROR
F
m

F
p

P
m
001
P
p


002


003


004
F = 125.2 kN
m
OK 
P
= 692 bar
m
OK
min.


BATTERY
= 125.2 kN
F
m
= 102.3 kN
= 692 bar P
m
= 565 bar
max.
BATTERY BATTERY
BATTERY 
BATTERY
LED
ON
LED
OFF
RESET
SW:S1J41AH
LED
OFF
3 SEC.
LED
ON
= 125.2 kN
OK
= 692 bar
OK
min.



13001

