Inhaltsverzeichnis
Werbung
TABLE 2 - TABLEAU 2 - TABELLE 2 - TABLA 2 - TAVOLA 2 (ITEM 10)
4. MAINTENANCE
The tool is robust, completely sealed, and requires very little daily maintenance.
Compliance with the following points should help to maintain the optimum performance
of the tool:
4.1) Thorough cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth taking care to remove any
residue, especially close to moveable parts.
4.2) Storage
When not in use, the tool should be stored and transported in the plastic case to prevent
damage. The case is suitable for storing the tool and accessories.
Plastic case: VAL P32, size 496x370x137 mm (19.5x14.6x5.4 inches) weighs 2,7 kg
(5.9 lbs).
4.3) Blade replacement
After extended use, the blades may loose
their cutting edge.
Replace the blades as follows:
– Remove the die set from the tool, operate
the tool to advance the blade (39) until
the split pin (38) in the ram (22) is
accessible.
– Use a suitable drift to remove the split
pin (38) and release the blade (39).
– Note the orientation of the blade (39).
Remove the blade and fit the replacement.
Fit the split pin (38) and release the oil
pressure.
5. RETURN TO Cembre FOR OVERHAUL
In the case of a breakdown contact our Local Agent who will advise you on the problem
and give you the necessary instructions on how to dispatch the tool to our nearest service
Centre; if possible, attach a copy of the Test Certificate supplied by Cembre together
with the tool or, if no other references are available, indicate the approximate purchase
date and the tool serial number.
29
6
(Ref. to Fig. 6 page 25)
38
22
ENGLISH
39
Werbung
Inhaltsverzeichnis
