Herunterladen Inhalt Inhalt Diese Seite drucken

Cembre B1350L-C Bedienungsanleitung Seite 11

Vorschau ausblenden Andere Handbücher für B1350L-C:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 21
102.3 kN
NR 13AB485
P
= 692 bar
692 bar
m
565 bar
max.
min.
The capacitive menu selection button may not work if touched using
objects or when wearing gloves, therefore always operate it using a bare finger.
BATTERY
BATTERY
4.2)
SELECTION SCREENS: control parameters that cannot be set as automatic
upon start-up of the tool, can be changed by operating the touch button:
Enabling/disabling the LED Worklights (factory setting LED ON)
LED
ON
BATTERY 
LED
OFF
BATTERY
Return to original factory settings / firmware version
13001
When the 'RESET' screen is displayed, return the tool to its factory setting by operating
the touch button for at least 3 seconds; a beep will confirm the setting.
RESET
SW:S1J41AH
4.3)
WARNINGS: these appear during operation and notify the operator of the status
of the tool:
LED
OFF
BATTERY 
LED
ON
BATTERY
13001
RESET
SW:S1J41AH
11
OK
B1350
To make a selected screen operational and appear at each start-
OK
up of the tool, operate the touch button for at least 3 seconds; a
continuous beep will confirm the setting.
3 SEC.
3 SEC.
The RESET screen also shows the firmware version of the circuit board.
LOW BATTERY: replace the battery.
NOTE: when the battery Vage falls below a minimum safety threshold, the tool
will not start; although it is still possible to end the work cycle in progress.
BATTERY TEMPERATURE HIGH: remove the battery and wait until it cools
down.
NO. OF CYCLES TO MAINTENANCE REACHED:
the tool continues to work however, it is recommended that it is sent to Cembre
for a complete overhaul (see § 6).
NOTE: this message, together with a beep, will reappear when the tool has been
idle for 30 seconds.
BATTERY
13001
RESET
SW:S1J41AH
LED
OFF
ERROR
LED
ON
001
002
003
004
ERROR
001
002
003
004
When the screen is dis-
played, touch the button
for at least 3 seconds to
deactivate for reactivate
operation of the LED Work-
lights during tool use;
a continuous beep will con-
firm the setting.
ERROR
001
002
003
004

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

B1350l-caB1350l-ceB1350l-ct

Inhaltsverzeichnis