Connection To Computer - Cembre B1350L-C Bedienungsanleitung

4.4)
ERRORS: these appear during operation, combined with a beep and flashing
LED Worklights, to notify the operator of procedural or operational errors.
Message Error description
The pressure release button (5)


was pressed before the control
ERROR
ERROR
parameters were reached (Force/

Pressure).
 

ERROR
ERROR


Abnormal power consumption

ERROR


of the motor for more than 3
001
001

seconds.

 

The tool stops.

 001
001

002
002



Output voltage of the pressure
001
 

002

 transmitter is out of the pre-set

002

range.
003
003



002
 

Failure to reach the set pressure
003



003
within 30 seconds of continuous

004
 004
operation of the machine.


003
 

004
Overcharging of the battery with

004


protection tripping.

004
The tool stops.

Errors are displayed for about 30 seconds before being reset, but will
display repeatedly in the event of permanent anomalies.

5. CONNECTION TO COMPUTER

The memory card integrated in the tool records operating data from 200.000 cycles for
transfer via the USB cable supplied.
To view and manage this data, go to www.cembre.com and register in the dedicated area,
then download the free Cembre software CEM_SWBT01.
Keeping the Firmware of the tool updated, via free of charge download from here, will
optimise the tool's performance.
6. RETURN TO Cembre FOR OVERHAUL
In the case of a breakdown, contact your local Agent who will advise you on the
problem and give you the necessary instructions on how to dispatch the tool
to our nearest service Centre; if possible, attach a copy of the Cembre Test
Certificate supplied with the tool or, if no other references are available, indicate
the approximate purchase date and the tool serial number.
Solution
Repeat the work cycle and wait for the
motor to stop automatically.
Wait for the display to turn off (60 sec.)
or remove and re-insert the battery,
then re-start the tool.
If the error occurs frequently, contact
Cembre.
Repeat the work cycle; if the error
occurs frequently, contact Cembre.
Repeat the work cycle; if the error
occurs frequently, contact Cembre.
Wait for the display to turn off (60 sec.)
or remove and re-insert the battery,
then re-start the tool.
If the error occurs frequently, contact
Cembre.
12