Connection To Computer - Cembre B450ND-BV Bedienungsanleitung

3.2) Storage case
When not in use, the tool should be stored and
transported in the plastic case supplied to pre-
vent damage. The case, type VAL-P22, is suitable
for storing the tool, the accessories, up to 9 die
sets and pre-prepared compression connectors.
VAL-P22: Size 465x315x116 mm (18.3x12.4x4.6
inches). Weight 1,5 kg (3.3 lbs).
3.3) Routine maintenance
When the tool reaches the predetermined number of hours worked,
it will signal via an audible alarm that routine maintenance is
recommended.
The tool will continue to work, however 15 sec. after use an alarm comprising 3 beeps combined
with illumination of the worklights (2) will signal that its return to Cembre for service is recom-
mended (see section 5).

4. CONNECTION TO COMPUTER

The memory card integrated in the tool records operating data for transfer via the USB cable supplied.
To view and manage this data, go to www.cembre.com and register in the dedicated area, then
download the free Cembre software CEM_SWBT01.
Keeping the Firmware of the tool updated, via free of charge download, will optimise the tool's
performance.
5. RETURN TO Cembre FOR OVERHAUL
In the case of a breakdown contact our Area Agent who will advise you on the problem and give
you the necessary instructions on how to dispatch the tool to our nearest service Centre; if possible,
attach a copy of the Test Certificate supplied by Cembre together with the tool or fill in and attach
the form available in the "ASSISTANCE" section of the Cembre website.
9