Silvercrest SIKP 2000 E3 Bedienungsanleitung Seite 74

1) Place a suitable pan with contents in the middle of the hob
2) Insert the plug into the mains power socket. All indicator lamps illuminate
briefly. The appliance is now in standby mode.
If the temperature of the hob
"
If a cooking process has already taken place and the hob
temperature above 60 °C, the display
3) Press the "On/Off" button
and the indicator lamps "P"
NOTES
► If you do not place a suitable pan on the hob
within 30 seconds, the appliance will beep and switch to standby mode.
4) You can use the power level mode or the temperature stage mode to cook.
To select, press the "Mode"
–
In power level mode, the preset power level "
display
In power level mode, the pan is heated at varying speeds. The higher
the selected power level, the faster the pan is heated.
–
In the temperature stage mode, the preset temperature of "
appears on the display
When you are cooking in temperature stage mode, the appliance heats
the pan to the set temperature. As soon as the temperature falls below
the set temperature, the appliance heats up again. The temperature is
thus maintained at the desired level.
NOTES
► If there is no suitable pan on the hob
seconds which will repeat for approx. 2 minutes. The display
error "
cooking (see section Safety cut-off).
5) Press the "+"
or temperature is shown on the display
6) To switch off the hob
lamps go out. The appliance is back in standby mode.
SIKP 2000 E3
".
. The indicator lamp "P"
". Place a suitable pan with contents on the hob
or "-" buttons repeatedly until the required power level
, press the "On/Off" button
is less than 60 °C, the display
will read "
. The display shows the power level " "
and "On/Off" light up.
or make any settings
button .
lights up.
. The indicator lamp "°C"
, you will hear a beep after a few
.
.
will read
still has a
".
" appears on the
"°C
lights up.
shows the
to continue
. All indicator
GB │ MT │
71 ■