Steam Jet Function; Cleaning; Cleaning The Device - Silvercrest SDBK 2400 E4 Bedienungsanleitung

7. Finish ironing, set the temperature con-
troller 17 to MIN, set the steam flow
rate controller 3 to
mains plug.
8. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank 15 through the filling open-
ing in the water tank (under the lid 2).

7.6 Steam jet function

The steam jet function requires a high tem-
perature. Select a temperature setting be-
tween and MAX. For this purpose, the
water tank 15 must be at least one quarter
full. The steam flow rate controller 3 is locat-
ed to the left on the symbol
• Press the steam jet button while the
steam iron glides over the item of laun-
dry 4 .
• Wait a few seconds before you press
the steam jet button 4
NOTE:
• For smoothing items of clothing that are
hanging up, you can use the steam jet
Button in a vertical position.

8. Cleaning

DANGER!
Pull the mains plug out of the wall socket
before you clean the steam iron.
Allow the device to cool down before
cleaning.
CAUTION:
Do not use any astringent or abrasive
cleaning agents.
10 GB

Cleaning the device

• For cleaning the device, use a soft,
and pull out the
moistened cloth.
• Dirt can be removed from the sole
plate 20 using commercially available
cleaning agents for chrome, silver or
stainless steel.
• Residues that have melted on can be re-
moved by heating the steam iron up to
the MAX setting and then ironing an
old cotton cloth.
Self-cleaning
CAUTION:
Do not put vinegar, limescale remover
. or any other additives into the water
tank 15. Additives can damage the de-
vice.
If you use tap water, you should run the self-
again.
cleaning cycle after every use. Otherwise
use the self-cleaning cycle at least twice per
month.
1. Fill the water tank 15.
2. Place the steam iron in the stand 7.
3. Connect the mains plug with the wall
socket.
4. Set the steam flow rate controller 3 to
ler 17 to MAX.
5. Wait until the temperature control
lamp 14 goes out.
6. The switch 11 is in the position
up the steam iron together with the
stand 7.
7. While doing so, hold the device hori-
zontally over a heat-resistant household
dish.
8. Press the 18 SELF CLEAN button and
hold it down. Limescale residues will now
be ejected with steam and hot water from
the steam outlet holes in the sole plate 20.
Hold the button down until no more steam
or water emerges.
and set the temperature control-
. Pick