Auping Ultimate Climate Gebrauchsanweisung Seite 36

3859_bw.qxp:bw 30-10-2008 14:23 Pagina GB10
The raised position of the head and
foot ends shows that the mattress has
been dried.
D. Change drying start time
1. Press and release programming
key P.
2. Press the drying key. The symbol in
the display
Depending
settings, the display shows 'on dry',
'off dry' or 'on AUTO'. Use the + and
-- keys to change the setting.
on dry = program runs single cycle
off dry = program off
on AUTO = program starts and stops
every day at the set times
3. Select 'on dry' to start the program
for single cycle.
4. Press confirmation key SET once to
change the start time. The display
shows 'on'.
5. Press the + and -- keys to set the
start time. First set the hours for
the start time. Press SET to confirm.
GB10
starts flashing.
on your previous
6. Then use the + and - keys to set the
minutes. Again press SET to
confirm. A single tone will sound to
confirm that the program is saved.
The drying function is best used after
leaving your bed in the morning. The
drying function heats the mattress at
maximum power, thereby evaporating
all the moisture from your mattress.
E. Starting the heating program every
day
You can also choose to have the
program run daily.
1. Press and release programming
key P.
2. Press the drying key.
3. Select 'on AUTO'.
4. Press programming key SET once
to change the
The display shows 'on'.
5. Press the + and -- keys to set the
start time. First set the hours for
the start time.
Press SET to confirm.
6. Then use the + and - keys to set the
minutes. Again press SET to
confirm. A single tone will sound to
confirm that the program is saved.
start time.