Auping Ultimate Climate Gebrauchsanweisung Seite 34

3859_bw.qxp:bw 30-10-2008 14:23 Pagina GB8
Start heating
Body zone
Foot zone
Stop heating
Start drying
Current time
4.3.3 Setting/adjusting personal
preferences
Although the Ultimate Climate is pre-
programmed on delivery (see Chapter
4.3.2: Pre-programmed settings) you
can always adjust these settings to
your personal
example if you find that the heating
level of the body zone is too low. In
this chapter you can read which
settings you can program yourself.
Please note: If during programming
you do not press any key for more
than ten seconds, the programming
cycle will stop without saving the
changed settings. The indication bars
will disappear from the display. The
pilot lights will go out. In that case
press the programming key to restart
the program. Press programming key
P to break
Any settings entered up to that point
are not saved.
GB8
09.00 p.m.
level 4
level 4
09.00 a.m.
11.00 a.m.
00.00 set time
preferences, for
off programming.
A. Change heating level and
heating start and
end time
1. Press and release the programming
key P.
2. Press the heating key for the foot
zone or body zone that you want to
change. The symbol starts flashing
in the display. Depending on your
previous settings, the display
shows 'on', 'off' or 'on AUTO'. Use
the + and -- keys to change the
setting.
on HEAT = program runs single
cycle
on AUTO = program starts and
stops every day at the
set times
off HEAT = program off
3. Select 'on' to start the program for
single cycle.
4. Set the level of both the body and
foot zones by pressing a number of
times on the + and -- keys.
5. Press confirmation key SET once to
change the start time. 'on' appears
in the display.
6. Press the + and -- keys to set the
start time. First set the hours for