Chapter 5.3 Cleaning; Installation; To Operate Safely - Ugolini DELICE Gebrauchsanweisung

DELICE
1 TECHNICAL CHARACTERISTICS
Transparent removable bowls
Capacity of each bowl, approx.
Dimensions:
width
depth
height
Net weight, approx.
Gross weight, approx.
Adjustable thermostats
Noise level lower than 70 dB (A)
IMPORTANT
Electric specifications: read the informa-
tion on the data plate of each single
dispenser, situated on the underside.
The serial number of the units is prece-
ded by #
The manufacturer reserves the right to make
changes without any prior notification.
2 INTRODUCTION
Read this instruction manual carefully to know
the specifications of the dispenser. As all
mechanical products, this unit requires cleaning
and maintenance. Its working order can be
compromised by possible errors made by the
operator during disassembly and cleaning. For
this reason it is important that the staff in charge
of the dispenser is qualified to carry out the day
to day operations, which are dismantling,
cleaning, sterilisation and reassembly.

3 INSTALLATION

1 - Remove the dispenser from the packaging.
( T h i s s h o u l d b e k e p t f o r a n y f u t u r e
requirement)
2 - C h e c k t h e d i s p e n s e r h a s n o t b e e n
damaged during transport. The forwarding
agent must be notified immediately of any
claim.
3 - Install the dispenser on a counter top that
8
4 - B e f o r e c o n n e c t i n g t h e d i s p e n s e r
DELICE
n 1
l 5
cm 24
cm 32
cm 49
kg 8
kg 13
n 2
Ensure that the unit is grounded cor-
rectly; if not it may cause electric shock
to persons or damage the dispenser.
5 - The dispenser does not leave the factory

4 TO OPERATE SAFELY

1 - Read the instruction booklet before using
2 - Use the dispenser only if it is grounded
3 - Do not use extension cords to connect the
4 - Do not operate the dispenser if it is not
5 - Do not place fingers or objects in the
6 - Do not open the dispenser for cleaning or
7 - Do not remove the container when the unit
will support its weight, even with a full load.
electrically check that the voltage (in the
network) is as shown on the data plate.
Plug the unit into a grounded, protected
single phase electrical supply according to
the applicable electrical codes and the
specifications of your machine. If the
dispenser has no plug, conforming to the
regulations in your Country, to the cable,
supplied with an earthing pin or earthing
contact and suitable to currents of at least
10A 250V (for areas with tension of 220V-
230V 50-60Hz) and 20A 250V (for areas
with tension of 100-115V 50-60Hz). If you
want to make a fixed connection to the
network, connect the cord to a bipolar wall
breaker with a contact gap of at least 3mm.
not use extension cords to connect the unit
electrically.
ATTENTION
presanitized and sanitized. Prior to use it
mus t be d is ass embled, c le aned an d
sanitized according to the instructions in

chapter 5.3 CLEANING.

the dispenser.
correctly.
dispenser electrically.
closed and blocked with screws.
cooling fissures and faucet outlet panels
louvers.
maintenance without ensuring it has been
disconnected from the electricity.
Ugolini S.p.A.