Ugolini DELICE Gebrauchsanweisung Seite 10

DELICE
5. 3. 1 DISASSEMBLY
ATTENTION
Before proceeding to disassemble any
component always disconnect the unit
from the electricity removing the plug or
switching off the 2 pole wall breaker.
1 - Empty the bowl and remove the lid
2 - Remove the mixer from the central shaft
3 - D i s m a n t l e t h e f a u c e t f o l l o w i n g t h e
sequence shown (see fig. 1)
4 - Remove the container, lifting it upwards.
5 - Remove the drip-tray and empty it.
5. 3. 2 CLEANING
ATTENTION
Before cleaning disconnect the dispen-
ser from the electricity taking out the
plug or turning off the outside switch on
the wall.
1 - Prepare approx. four litres (2 gallons) of
hot water (45-60° C) and specific detergent
in a bowl according to the instructions of
the manufacturer; a solution, which is too
concentrated, may cause damage to the
parts to be washed, one that is too diluted
10
figure 1
IMPORTANT
Do not wash any component of the
machine in the dishwasher.
will not clean adequately. Do not use abra-
sive detergents.
IMPORTANT
Use detergents compatible with the pla-
stic parts to avoid damaging the dispen-
ser.
2 - Use a suitable brush and carefully clean all
the parts in contact with the drink
ATTENTION
Do not use excessive amounts of water
near the electric components of the
dispenser when washing it as this can
cause electric shock or damage the
dispenser.
3 - Rinse all the washed parts in running
water.
5. 3. 3 SANITIZING
The dispenser must be sanitized prior to
starting the machine. Do not allow the unit to sit
f o r e x t e n d e d p e r i o d s o f t h e t i m e a f t e r
sanitization
1 - Before starting the procedure described
below wash hands with an anti-bacterial
soap.
2 - Prepare at least. four litres of hot water
(45-60°C) and sterilising product legally
approved in your Country, following the
instructions of the manufacturer. If there is
no specific sterilising product prepare a
s o l u t i o n o f w a t e r a n d b l e a c h i n t h e
following ratio: 1 tbsp: 2 litres of water.
3 - Immerse all the parts to be sterilised in the
solution for the time indicated by the
manufacturer.
4 - Allow the sterilised parts to air dry on a
Ugolini S.p.A.