End Of Work; Cleaning The Machine - GGP ITALY 102 Gebrauchsanweisung

When the grass-catcher is full
you will hear a sound warning.
At this point:
– disengage the blades
( 4.7) and the sound will
stop;
– lower the engine speed;
– shift into neutral (N) ( 4.22
Mechanical transmission
or 4.32 Hydrostatic trans-
mission) and stop moving
forward;
– engage the parking brake on
slopes;
– pull out the lever (1- if fitted) or grasp the rear handle (1a) and
tip up the grass-catcher to empty it;
– close the grass-catcher so that it hooks onto the pawl (2).
5.4.7 Unblocking the collector channel
Cutting very tall or wet grass, particularly at excessively high
speed, can clog up the collector channel. If this happens pro-
ceed as follows:
– stop moving forward, disengage the blades and stop the
engine;
– remove the grass-catcher or stone-guard;
– remove the grass cuttings; you can reach them from the exit
of the collector channel.
WARNING!
This job must only be performed with
the engine turned off.
EN 22
1a 1
2
5.4.8 End of mowing
When you have finished mowing, disengage the blades, lower
the engine speed and ride the machine with the cutting deck
raised as high as possible.

5.4.9 End of work

Stop the machine, move the throttle
to «SLOW» and turn off the engine
by turning the key to «OFF».
When the engine has stopped,
close the fuel stopcock (1) (if fitted).
WARNING!
To avoid backfire, position the throt-
tle on «SLOW» for 20 seconds before stopping the
engine.
WARNING!
Always take out the ignition key
before leaving the machine unattended!
IMPORTANT
To keep the battery charged, do not
leave the key in the «ON» position when the engine is not run-
ning.

5.4.10 Cleaning the machine

After each mowing, clean the outside of the machine, empty the
grass-catcher and shake it to remove residual grass and earth.
1