GGP ITALY 102 Gebrauchsanweisung Seite 85

shaft and insert the pin (3) using a hammer. Make sure the end
comes right through to the opposite side.
NOTE
To avoid damage to the steering wheel,
use a punch or a screw-driver of the same size as the pin
when hammering it through the hole.
3.3 FITTING
THE SEAT
2 2
Mount the seat (1) on
the plate (2) using the
screws (3).
3 3
3.4 MOUNTING THE
FRONT BUMPER
(if provided)
Mount the front
bumper (1) on the bot-
tom of the frame (2)
using the four screws
(3).
1
EN 10
3 3
2
3
3.5 ASSEMBLY AND CONNECTING THE BATTERY
To access the battery (1) , remove the inspection hatch (2),
which is fixed with a latch (3).
1
First connect the red wire (4) to the positive pole (+) and then
1 1
the black wire (5) to the negative pole (–), using the screws sup-
plied as shown.
Apply silicone
grease to the ter-
minals and check
that the protective
cap for the red
wire (4) is in
place.
Reassemble the
inspection hatch
(2), fixing it in
place with the
latch (3).
3
4
5
3
2
1