GGP ITALY 102 Gebrauchsanweisung Seite 95

When moving the machine:
– disengage the blades;
– bring the cutting deck to the highest position (position «7»);
– put the accelerator control between the «SLOW» and
«FAST» positions.
Mechanical transmission
Push the pedal down as far as possible (
the gear change lever into 1st gear (
Keep the pedal pressed down and release the parking brake.
Slowly release the pedal to shift from «brake» to «clutch»,
thus operating the rear wheels (
WARNING!
The pedal has to be released grad-
ually, as a sudden engagement may cause the vehicle
to tip over and the driver to lose control.
Gradually reach the desired speed using the throttle and gear
lever. To change gear, press the clutch halfway down
( 4.21).
Hydrostatic transmission
Disengage the parking brake and release the brake pedal
( 4.31).
Press the drive pedal (
the required speed by progressively increasing pressure on
the pedal and moving the accelerator.
EN 20
4.21) and move
4.22).
4.21).
4.32) in direction «F» and reach
WARNING!
Drive must be engaged as
described ( 4.32) ) to prevent sudden engagement
from causing tipping up and loss of control of the
vehicle, particularly on slopes.
5.4.3 Braking
First reduce the machine's speed by reducing the engine's
r.p.m., and then press the brake pedal (
down the machine until it stops.
Hydrostatic transmission
The machine already slows down considerably by just releas-
ing the drive pedal.
5.4.4 Reverse
IMPORTANT
Reverse must be engaged only when the
machine has stopped moving.
Mechanical transmission
Press the pedal until the machine stops and then go into
reverse by shifting the lever sideways and into position «R»
( 4.22). Gradually release the pedal to engage the clutch
and then begin moving in reverse.
Hydrostatic transmission
When the machine has stopped moving, start reversing by
pressing the drive pedal in direction «R» (
4.21 or 4.31) to slow
4.32).