GGP ITALY 102 Gebrauchsanweisung Seite 108

PROBLEM
5. Starting is difficult or the engine runs
erratically
6. Poor engine performance during cutting
7. The motor shuts down whilst working
8. The blades do not engage or do not stop
promptly when they are disengaged
9. Uneven cut and poor grass collection
LIKELY CAUSE
– fault in carburation
– forward speed too high compared
to cutting height
The safety device of the electronic
circuit board has cut in due to:
– the safety devices have cut in
– problems with engagement mechanism
– cutting deck not parallel to the ground
– blade cuts badly
– forward speed too high compared
to the height of the grass (
SOLUTION
– clean or replace the air filter
– empty the fuel tank and refill with fresh fuel
– check and replace the fuel filter
if necessary
– reduce the forward speed and/or raise
the cutting deck (
Turn the key to «STOP» and look for the cause
of the problem:
– check that the conditions allowing starting are
met (
– contact Your Dealer
– check the tyre pressure (
– realign the cutting deck (
– contact Your Dealer
– reduce forward speed and/or raise
5.4.5) the cutting deck
5.4.5)
5.2.b)
5.3.2)
6.3.1)
EN 33