GGP ITALY 102 Gebrauchsanweisung Seite 89

4.8 CUTTING HEIGHT ADJUSTMENT LEVER
There are seven positions for this lever (shown as «1» to «7» on
the label), which correspond to various heights between 3 and 8
cm.
– To go from one height to another, press the release button at
the end of the lever.
4.9 LEVER FOR TIPPING THE GRASS-CATCHER
(if present)
This pull-out lever tips and empties the grass-catcher. This
means less work for the operator.
Mechanical transmission
4.21 CLUTCH / BRAKE PEDAL
This pedal has
two functions:
during the first
part of its trav-
el it acts as a
clutch, engag-
ing and disen-
gaging drive to
the wheels,
and in the sec-
ond part it acts
as a brake on
the rear
wheels.
EN 14
4.22 SPEED CHANGE LEVER
This lever has seven positions for the 5 forward speeds, the
neutral position «N», and reverse «R».
To go from one speed to another, press the pedal (4.21)
halfway and shift the lever as shown on the label.
4.21
4.31 BRAKE PEDAL
This pedal works the brake on the rear wheels.
4.22
R N
4.32 DRIVE PEDAL
This pedal engages drive in the wheels and controls the
1
machine's forward and reverse speeds.
2
3
4
5
– To engage forward drive, press it towards «F» with your
IMPORTANT
Do not keep the pedal halfway
between clutch engagement or disengagement, as this can
cause overheating and damage the transmission belt.
NOTE
When the machine is moving, keep
your foot off the pedal.
WARNING!
Only shift into reverse when the
machine has stopped moving.
Hydrostatic transmission
toe-cap. As you increase the pressure on the pedal, the