Inhaltsverzeichnis
Werbung
Rengøring
Rengør regelmæssigt maskinkappen med en blød klud, helst efter hvert brug. Sørg for at
ventilationshullerne er fri for støv og snavs. Brug en blød klud, der er vædet i sæbevand til at
fjerne hårdnakket snavs. Brug ingen opløsningsmidler, så som benzin, alkohol, ammoniak,
osv. Den slags stoffer beskadiger kunststofdelene.
Smøring
Maskinen behøver ingen ekstra smøring.
Fejl
Skulle en fejl opstå, f.eks. pga. slidtage af en enhed, kontakt venligst serviceadressen på
garantibeviset. På bagsiden af denne manual finder du en tegning med alle dele, der kan
bestilles.
Miljø
For at undgå transportbeskadigelse leveres maskinen i en solid emballage. Emballagen er så
vidt muligt lavet af genbrugsmateriale. Genbrug derfor emballagen.
Defekte og/eller kasserede elektriske eller elektroniske maskiner skal afleveres på
en genbrugsplads.
Garanti
Læs det separat vedlagte garantikort for garantibetingelserne.
DK
90
Always check that the power supply corresponds to the voltage on the rating plate.
Your machine is double insulated in accordance with EN 50144; therefore no
earthwire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable for the power input of the machine. The minimum
conductor size is 1.5 mm
3.
ASSEMBLY
Prior to mounting an accessory always unplug the tool.
Mounting the side-handle
Fig. 1
The side handle can be used for both left-hand and right-hand control.
•
Fasten the side handle for left-hand operation on the right-hand side of the machine.
•
Fasten the side handle for right-hand operation on the left-hand side of the machine.
Mounting the guard
Fig. 2
Mount the guard before using the machine.
Assembly
•
Place the guard (2) on the housing. Be aware that the notch of the guard falls across the
edge of the housing.
•
Place the fixing-ring (7+12) on the guard: the ring-holes have to be on the screw-holes.
•
Mount the guard en fixing-ring with help of the 4 screws and washers (8).
•
The closed side of the guard always has to point in the user's direction.
Be aware the screws are tightened well enough. Check regularly if the screws are
still fixed.
Disassembly
•
Remove the flange nut and the grinding disc with lower flange from the spindle.
•
Unscrew the 4 screws (with washers) en remove the fixing-ring.
•
Remove the guard from the machine.
Ferm
Ferm
2
. When using a cable reel always unwind the reel completely.
UK
7
Werbung
Inhaltsverzeichnis
