Assembly - Ferm PSM1010 Gebrauchsanweisung

GB
• Interruption of the mains plug, mains lead or
mains lead damage.
• Defect switch
• Smoke or stench of scorched isolation
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Class II machine – Double insulation –
You don't need any earthed plug.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in the
wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1,5 mm 2 . When using a cable
reel always unwind the reel completely.

3. ASSEMBLY

Prior to mounting an accessory always
unplug the tool.
Dust collection
Fig. 2
The sander has been carried out with a dust bag
(3) to keep the working surface clean. The dust
bag must be installed on the back side of the
machine, on the opening. It is necessary to empty
the dust bag regularly for an efficient use.
Empty it as follows:
• Turn the dust bag slightly and pull it out of the
machine's adapter.
• Empty the dust bag in a suitable place.
• Push the dust bag on to the machine's adapter
till it locks into place.
4
Remember that the dust extraction only
works when using perforated
sandpaper.
Replacing worn sanding paper
Fig. 3
Before assembly sanding paper always
remove the plug from the mains.
Replacing worn sanding paper
This machine is suitable for Velco ® sanding paper
and universal sanding paper.
Before assembly sanding paper always
remove the plug from the mains.
Velcro ® sanding paper (189 x 92 mm)
The sandpaper is fixed by Velcro ® fastener to
facilitate the replacement.
• Simply pull off the sanding paper.
• Press the new one in the centre of the sanding
sole.
Universal sanding paper (240 x 92 mm)
Fig. 3
The sanding machine is provided with a rectangle
sanding sole. By tightening the sandpaper it does
not wear out so fast, so it will wear well longer.
• Open the back paper clamp (4) by pulling the
handle (5) up.
• Install the sandpaper under the clamp. Put the
paper in the middle of the sanding sole and
look after the perforations in the paper. They
have to correspond with those on the sanding
sole, so that the dust can be exhausted.
• Push the handle back into its original position.
• Repeat the operation to fix the sand-paper on
the front side.
• Fix the sandpaper as tight as possible.
Coarse sand-paper (grain 50) removes in general
the bigger part of the material and fine sand-paper
(grain 120) is used for the finishing.
Replacing the sanding sole
The sole has to be replaced when the Velcro has
been worn out.
Ferm Ferm 41