DENTSPLY G90 Gebrauchsanweisung Seite 15

inserts used during the procedure (refer to the Infection
Control information booklet and the Cavitron Ultrasonic
Inserts Directions for Use for cleaning and sterilizing
instructions).
2. Clean and disinfect the handpiece cable assembly by
applying a medically approved non-immersion type
disinfectant solution* carefully following the instructions
provided by the solution manufacturer. To clean the cable,
generously spray disinfectant solution on a clean towel
and wipe the cable and connector. Discard used towel. To
disinfect the system, generously spray disinfectant on a
clean towel and wipe the cable and connector. Allow the
disinfectant solution to air dry.
3. Clean and disinfect all surfaces of the dental treatment
control head according to the manufacturer's instructions.
4. Connect a sterilized Steri-Mate
mating cable connector.
5. Hold the handpiece (without an insert installed) over a
sink or drain. Activate the foot control and flush water
through handpiece for at least thirty seconds.
6. Place a sterilized insert into the handpiece.
Shut down at the end of the day
1. Flush the DENTSPLY Cavitron Built-In ultrasonic system
according the dental treatment unit manufacturer's
instructions.
®
handpiece onto its
2. Remove any ultrasonic inserts and the Steri-Mate
handpiece. Clean and sterilize the handpiece and
all inserts used during the procedure (refer to the
Infection Control information booklet and the Cavitron
Ultrasonic Inserts Directions for Use for cleaning and
sterilizing instructions).
3. Clean and disinfect the handpiece cable assembly
by applying a medically approved non-immersion
type disinfectant solution* carefully following the
instructions provided by the solution manufacturer.
To clean the cable, generously spray disinfectant
solution on a clean towel and wipe the cable and
connector. Discard used towel. To disinfect the system,
generously spray disinfectant on a clean towel and
wipe the cable and connector. Allow the disinfectant
solution to air dry.
4. Clean and disinfect all surfaces of the dental treatment
control head according to the manufacturer's
instructions.
5. Place the cable connector into the handpiece holder for
storage.
6. Turn OFF the power and water to the dental treatment
unit.
*NOTE: Water-based disinfection solutions are preferred. Some alcohol-
based disinfectant solutions may discolor the handpiece cable
and connector.
®
ENGLISH • 13