Notes On Cable Routing - HBM C2 Montageanleitung

Connection
tensions, care must be taken to ensure a satisfactory connection with the low­
est possible transfer resistance and good insulation.
When using the six‐wire technique, the effects of resistance changes in the
extension cable are compensated. If you extend the cable with the four‐wire
technique, the sensitivity deviation can be rectified by adjustment. Temperature
effects though are only compensated with the operation using six‐wire tech­
nique.
6.6

Notes on cable routing

The load cell connecting cable should be routed so that any condensed water
or dampness forming on the cable can drip off. It must not be led to the load
cell. In addition, it must be ensured that no dampness can penetrate the open
end of the cable.
12 C2
A1683-2.0 HBM: public