Special Notes - HBM C16i Serie Montageanleitung

14

Special notes

Type C16 load cells are metal--clad by laser--welding and made from rustproof materials. Therefore
they comply with protection class IP68 according to EN 60 529 (IEC 529) under the stated test
conditions (see Technical data).
In general, the load cells permit steam jet cleaning. However, the conditions for max. pressure,
temperature, etc., stated in the EN 60 529 for protection class IP69K, must be observed.
When EPO3/50t + C16/EPU44A or C16/ZOU44A mounting parts from HBM are used, the integral
rotation stop device, described in chapter 2 (Mounting), can be used. With customised mounting
parts, HBM provides drawings showing the position and mounting of the rotation stop. In this case,
special attention must be paid to the observance of the tolerances stated for the dowel pin position,
to prevent the load cells from being damaged.
Only when the HBM specifications are followed will the HBM warranty for the product be valid.
The C16/ZOU44A load introduction parts accessory kit can be used as an economical alternative
for load cells with nominal loads up to 60t. In this case, however, the maximum load for each load
cell must not exceed 40t.
Downloaded from www.Manualslib.com
Wägezelle
manuals search engine
Load cell Capteur de pesage
• •
MA.C16i.0def -- 284.00--1053.4 -- Version a -- 05.04.2001
C16i...
français (page 18 ... 25) = en préparation