Configuration And Set-Up - Telecom Behnke 20-2907A-IP Anleitung

Instructions Behnke IP camera
GB GB
Camera access via a browser

3.5. Configuration and Set-up

Requires administrator authorization.
On this page, entitled "Configuration", you
can access and change general network set-
tings for your camera. By default, your camera
is set to make use of the dynamic IP protocol
(DHCP). The entry fields for an IP address, the
gateway, the subnet mask and the DNS server
are consequently deactivated and cannot be
changed manually. Should you not have a
DHCP server or in case, you want to use static
configuration for different reasons, please
use the "Static IP" mode. Where you want
56
to use your proprietary NTP server, please
enter the corresponding data to the field "NTP
server". The fields MAC (serial number) and
camera name only serve information pur-
poses and are consequently greyed out at all
times. To save the changes made, please click
"Send"; use "Cancel" to leave this page. All
changes not yet confirmed will be lost.
www.behnke-online.com