Sealings; Maintenance And Care; Original Behnke Components; Configuration And Set-Up - Telecom Behnke 20-2907-IP Kurzanleitung

Behnke IP Camera 20-2907-IP/21-2907-IP, 43-9587
GB GB
Introduction

Sealings

To protect your device from any dampness,
please make sure the included sealings have
been put in place correctly upon installation
of your door intercom station. The seal needs
to properly connect to the in-wall or on-wall
housing or in case of a wall cavity mounting,
it needs to connect to the level surface of the
mounting ground respectively! In-wall housings
are available for installation in masonry or
in drywall. You will find the most important
mounting information on a sticker inside the
respetive housing. Please order the mounting
set for mounting in drywall (order # 20 -5216)
as well.
24

Maintenance and Care

You have chosen high-quality Behnke products
with front panels made from various materials.
Regardless of the material, all front panels
require regular cleaning in sufficiently short
intervals using a cleansing agent appropriate
for the material in question. This prevents early
aging and patina formation on the surface.

Original Behnke components

Please do not use any other than original
Behnke components or spare parts – this also
applies to POE injectors! This will guarantee
an intercom operation free from interference.
Please mount and install the electronics only
in the provided housings. Using a third-party
housing or not the housing provided for
mounting, we cannot guarantee functioning and
approval of your door intercom.

Configuration and Set-up

To configure your Behnke IP camera, please
use the web frontend (for system requirements,
please cf. page 21). Please see the "Help"
section in the Behnke IP camera's web frontend.

Prescriptions

Please adhere to the relevant prescriptions for
the installation of communications and elec-
tronic systems as well as the applicable, current
norms and regulations on network technology!
www.behnke-online.com