Programming; Configuring Dip Switches; Operator Panel - Siemens SED1 Betriebsanleitung

4.2

Programming

4.2.1 Configuring DIP switches

Where are the DIP
switches?

4.2.2 Operator panel

18/62
Siemens Building Technologies
Landis & Staefa Division
On frame sizes A to C, the DIP switches are below the operator panel underneath a
folding cover next to control terminals 23 to 26 (see pictures on page 12).
On frame sizes 4, 5 and 6, remove the whole front cover (only the lower cover for frame
size 7); see picture on page 14.
  
 #   
$%
$''

 
 

 


 

  
  



RUN
I
Button
O
STOP
Button
RS 485
Interface
The keypad comprises membrane-type keys as well as an integral 4-digit, 7-segment
LED display. The keys are limited to [run], [stop], [up], [down] and [P]. You can access
and change all parameters using these keys.
SED1 Variable Speed Drive
Programming
    ! "
 

&
 

 

  
  
&



($%  
P
The settings of the five DIP
switches must agree with
parameters P023 or P323
LED
Display
Up/Increase
Down/Decrease
Parameterisation
Button
CM1U5191X
01.2000