Parkside PHD 100 A1 Originalbetriebsanleitung Seite 36

GB MT
cur within the vicinity of air inlets.
Caution! To avoid damage to the
equipment and any possible
person injury resulting from this:
• Do not work with damaged or incom-
plete equipment, or with equipment
that has been converted without the
approval of the manufacturer. Before
initial operation, have a specialist
check that the required electrical pro-
tection measures are in place.
• Never operate the pressure washer
if the power supply cable or other im-
portant parts, such as the high-pres-
sure hose or the gun, are damaged.
• Protect the pressure washer from frost
and dry running.
• Use only original accessories and do
not carry out conversion work on the
equipment.
• Please read the notes in the operating
instructions on the topic of "mainte-
nance and cleaning". Any measures
above and beyond these, particularly
opening the equipment, are to be car-
ried out by an electrician. In the case
of repairs, always contact our service
centre.
• The washer was designed for opera-
tion with a neutral detergent based on
a biologically decomposable anionic
tenside. Other detergents or chemical
substances could impair the safety of
the washer and damage it.
• If you come into contact with cleaning
agents, rinse with plenty of clean wa-
ter.
• Water that has passed through a
backflow preventer is classified as un-
drinkable.
• High-pressure hoses, fittings and
36
couplings are important for machine
safety. Use only high-pressure hoses,
fittings and couplings recommended
by the manufacturer.
• To ensure machine safety, use only
original replacement parts from the
manufacturer or replacement parts
authorised by the manufacturer.
Electrical safety:
Caution: to avoid accidents and
injuries from electric shocks:
• The plug and socket of an extension
cable must be water-tight!
Unsuitable extension cables can
be dangerous as people can be
harmed by an electric shock!
• Protect the electric plug connections
against moisture.
• If there is a risk of flooding, fix the
plug connections in an area that is
safe from flooding.
• Ensure that the mains voltage match-
es the specifications on the rating
plate.
• The electrical installation shall be ac-
cording to national wiring rules.
• Connection to the mains must be car-
ried out by an experienced electrician
and meet the requirements of IEC
60364-1.
• The device must only be connected to
a mains socket via a residual-current
circuit breaker (RCD) with a rated
leakage current of not more than
30 mA. Fuse: at least 6 ampere.
• Before each use, check the equip-
ment, cable and plug for damage.
• If the power cable for this equipment