Operation; Spark Plug - Texas TG470 Bedienungsanleitung

1. Release the handle/engine brake lever on which the engine is mounted and the
engine will be turned off.

8. Operation

1. Hold the handle/ engine brake lever on which the engine is mounted activated.
Please draw attention to the following during operation.
-
- The exhaust must not be black. If this occurs the load is too high or the engine has
not been adjusted correctly.
No incorrect noises and vibrations.
-
- If any of the above appears, turn off the engine and adjust it or contact your Power
Line dealer.

9. Spark plug

Remove the sparking plug cover. (Caution, it may be hot, if the engine have been
-
running).
Make sure the cover is intakt
-
Brush off dirt from the spark plug.
-
- Use a spark plug wrench to loosen the spark plug.
Inspect if the isolation of the spark plug is intact.
-
Clean the spark plug with a steel brush.
-
Measure the electrode distance; make sure not to damage the electrode.
-
The distance should be: 0,7 – 0,8 mm.
-
- If the sparking plug is okay, put it back in its place.
Otherwise replace using Denso type W20EPR-U.
Put the sparking plug cover back in its place.
-
See fig 1, pos 1.
-
PROCEDURE
OPERATION
NOTE
PROCEDURE
14