Stopping The Engine; Operation; Sparking Plug - Texas Power Line TG500B Bedienungsanleitung

7. Stopping the engine

1. Turn the gas control to a "low" position and engine will stop running.
2. Turn the fuel tap to the "off" position
See figur 4, on page 2.

8. Operation

1. When the engine has been started move the choke gradually to the right.
2. Adjust the gas to the requested speed.
See figure 2, on page 2.
Please draw attention to the following during operation.
-
Exhaustion must not be black. If the exhaustion is black the load is too high or
-
the engine has not been adjusted correctly.
No incorrect noises and vibrations.
-
If these appear turn off the engine and adjust it. Contact your Power Line dealer
-

9. Sparking plug

Remove the sparking plug cover.
-
Brush off dirt from the sparking plug.
-
Use a sparking-plug wrench to loosen the sparking plug.
-
Inspect if the isolation is intact.
-
Clean the sparking plug with a steel brush.
-
Measure the electrode distance, make sure not to damage the electrode.
-
The distance should be: 0,7 – 0,8 mm
-
If the sparking plug is okay, put it back in its place.
-
Put the sparking plug cover back in its place.
-
PROCEDURE
OPERATION
NOTE
PROCEDURE
17