Stop; Operation; Spark Plug - Texas TG370 Benutzerhandbuch

8. Stop

1. Turn the gas control to a "low" position and let the engine run for a while.
2. If the engine is mounted with a cabelregulated throttle, full stop.
See fig 4, page 3.

9. Operation

1. When the engine has been started move the choke gradually to the right.
2. Adjust the gas to the requested speed.
See fig 4, page 3.
Please draw attention to the following during operation.
-
The exhaust must not be black. If this occurs the load is too high or the
-
engine has not been adjusted correctly.
No incorrect noises and vibrations.
-
If any of the above appears, turn off the engine and adjust it or contact your
-
Power Line dealer.

10. Spark plug

Remove the sparking plug cover. (Caution, it may be hot, if the engine have been
-
running).
Brush off dirt from the spark plug.
-
Use a spark plug wrench to loosen the spark plug.
-
Inspect if the isolation is intact.
-
Clean the spark plug with a steel brush.
-
Measure the electrode distance, make sure not to damage the electrode.
-
The distance should be: 0,7 – 0,8 mm
-
If the sparking plug is okay, put it back in its place.
-
Put the sparking plug cover back in its place.
-
See fig 1, pos 1, page 2.
-
PROCEDURE
OPERATION
NOTE
PROCEDURE
21