Operation; Spark Plug - Texas TG485 Bedienungsanleitung

8. Operation

1. Hold the handle/ engine brake lever on which the engine is mounted activated.
- Please draw attention to the following during operation.
- The exhaust must not be black. If this occurs the load is too high or the engine has
not been adjusted correctly.
No incorrect noises and vibrations.
-
If any of the above appears, turn off the engine and adjust it or contact your Power
-
Line dealer.

9. Spark plug

Remove the sparking plug cover. (Caution, it may be hot, if the engine have been
-
running).
Brush off dirt from the spark plug.
-
- Use a spark plug wrench to loosen the spark plug.
Inspect if the isolation is intact.
-
Clean the spark plug with a steel brush.
-
Measure the electrode distance; make sure not to damage the electrode.
-
The distance should be: 0,7 – 0,8 mm.
-
If the sparking plug is okay, put it back in its place.
-
Otherwise replace using Denso type W16EPR-U.
Put the sparking plug cover back in its place.
-
- See fig 1, pos 1.
OPERATION
NOTE
PROCEDURE
13