Electrical; Stopping The Engine; Operation - Texas TG500A Bedienungsanleitung

6.1. Starting – ONLY APPLIES FOR MACHINES WITH ELECTRIC-START.
1. Open the fuel tap.
2. Turn the choke to the right, if the engine is already warm it is not necessary to use the
choke.
3. Turn the engine's gas control a little to the left.
4. Turn the machines ignition switch to the "ON" position.
5. Turn the key to the start position. If the engine does not start after 5 seconds, wait
another 10 seconds and try again.
6. Regulate the choker until the engine is running evenly.
See figures 1, 2, 4, 5, 6 on page 3.
otherwise the engine's starter and battery will be damaged.

7. Stopping the engine

1. Turn the gas control to a "low" position and let the engine run for a while.
2. Turn off the machine on the ignition switch.
3. Turn the fuel tap to the "off" position
4. If the machine is with electric-start, turn the key to the "off" position.
See figures 4, 5, 7 on page 3.

8. Operation

1. When the engine has been started move the choke gradually to the right.
2. Adjust the gas to the requested speed.
Please draw attention to the following during operation.
-
Exhaustion must not be black. If the exhaustion is black the load is too high
-
or the engine has not been adjusted correctly.
No incorrect noises and vibrations.
-
If these appear turn off the engine and adjust it. Contact your Power Line
-
dealer
PROCEDURE
Let go of the ignition key the moment the engine starts
PROCEDURE
WARNING
OPERATION
NOTE
14