Hach AN-ise SC Betriebsanleitung Seite 7

4.2 Sensor setup menu (Continued)
Calibration (continued)
Sensor code
Lab value correction
Enter the lab value.
1,2
Ammonium
1,3
Nitrate
1,2
Potassium
1,3
Chloride
Confirm the entry.
Correction result
1,2
NH –N
4
1,3
NO –N
3
1,2
K+
1,3
Cl
Information
1,2
NH –N
4
1,3
NO –N
3
1,2
K+
1,3
Cl
Settings
Name
Unit
Parameter
Temperature
Offset temperature
Response time
Datalog interval
1,2
K+ compensation
1,2
K+ concentration
1,3
Cl - compensation
1,3
Cl - concentration
Reset configuration
Maintenance
Sensor information
Sensor type
English
Entry of the sensor code
The laboratory values of the last matrix correction can be changed
Enter the laboratory values if 1-point matrix correction or 2-point matrix correction has
been selected
Entry of ammonium laboratory value
Enter the laboratory value for nitrate
Enter the laboratory value for potassium
Enter the laboratory value for chloride
Confirm the values entered
Display the correction results
Displays whether or not the ammonium correction was successful
Shows whether or not the nitrate correction was successful
Displays whether or not the potassium correction was successful
Displays whether or not the chloride correction was successful
Information on the matrix correction used per parameter
Matrix correction used for ammonium
Matrix correction used for nitrate
Matrix correction used for potassium
Matrix correction used for chloride
Enter or edit the name.
Up to 10 alphanumeric characters
Select either mg/L or ppm as the measurement unit
Select NH –N or NH and/or NO
4 4
Selection of °C or °F as temperature unit
Enter a temperature offset
Entry of the response time (30 sec to 300 sec)
Select the data log interval (OFF, 30 sec, 1 min, 2 min, 5 min, 10 min, 15 min and
30 min), 5 min is the factory setting
Select automatic potassium compensation:
On
Off
0 = compensation OFF
0.1–2000 mg/L Cl = Fixed compensation value
Only shown when K+ COMPENSATE is OFF
Select automatic chloride compensation:
On
Off
0 = compensation OFF
0.1–2000 mg/L Cl = Fixed compensation value
Only shown when Cl COMPNSATE is OFF
Resets the configuration to the factory setting
Information on the connected sensor
Name of the connected sensor
–N or NO
3 3
Operation
7